Menvier Security TS700 Especificaciones descargar pdf (Pagina 9)

Control Panel Installation

Proceed as follows:

1. Open the control panel by removing two

screws from the front cover. Removethecover

by slidingitup slightly todisengage the bottom

clip, disconnect the earth bonding cable from

the spade connection on the front cover, then

lift clear.

2. Notethepositionofthecableentriesasfollows:

(a) Plastic cable entriesand 20mm knock-outs

top and bottom for trunking.

(b) Eight 20mm cable entries for detection,

alarm and remote keypad cables.

(c) A 20mm cable entry for mains (240V)

above the mains input terminal block on

the right hand side of the control panel

back box.

+

The mains cable must enter the control

panel through its own cable entry and

must not be mixed with other cables.

3. Hold thecontrolpanelback boxintherequired

position (keyhole to the top) and mark the

centre of the keyhole position. Remove the

back box, drill and plug the hole.

4. Screw a No 10 screw into the plugged hole.

Re-position the back box and mark the

remaining four securing holes. Remove the

back box, drill and plug the holes.

5. Re-position the back box and pass all cables

into the base via the trunking holes or

knockouts, grommeting as appropriate.

6. Secure the back boxusingnotlessthan 30mm

x No 10 screws through the four dished 5mm

holes.

7. If required install and connect the following:

(a) Stand alone digicom or RedCARE STU.

(b) Plug-on digicom type DC54, DC58 or

DC58M.

(c) Output modules type CPA6.OM.

(d) Printer type DATAC or serial RS232 via a

printer adapter (MPA).

(e) Relay module type RM.3A.

+

When replacing the cover, always

ensure that the earth bonding lead is

connected to the spade connection

on the front cover.

Key-hole mounting Lid tamper Mains cable entry

Mains fused

terminal block

Mains

transformer

Printed Circuit Board (PCB)Earth bonding lead

(connected to front cover)

Space for a 7 Ah

lead acid battery

20mm cable

entries

Figure 5. TS790 & TS900 Control Panel Layout

TS790 & TS900 Installation Manual System Installation

5

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 67 68

Comentarios a estos manuales

Sin comentarios