Menvier Security TS700 Especificaciones descargar pdf (Pagina 14)

position the sounder responds as normal.

When the link is set to the enabled position the

sounder is only enabled when the remote

keypad programmable output is active. For

example,tomakethekeypadwardrespective

for ward A, program the output on the remote

keypad to "Sounder Control A" (type 064) and

set the "Ward Sounder Control" link to the

enabled position.

7. Finally clip the remote keypad cover onto the

base being careful not to trapany cables or to

obstruct the tamper switch.

Engineer’s Keypad

Normally all system programming will be carried

out from one of the installed remote keypads,

however sometimes it may be more convenient

to program the system at the control panel. This

can be achieved by using an “Engineers Keypad”

which is temporarily plugged on to the control

panel (JP2). To convert astandard remote keypad

to an “Engineers Keypad” an Engineer’s interface

lead is required which can be obtained from your

supplier (P/No. NETEKI).

TS900 Node Installation (TS900 Only)

The TS900 NODE allows the facility to add an extra

eight programmable detection circuits and two

programmable outputs. The Nodes are

connected on the “Node Network” and up to five

may be connected to the TS900 system.

Always ensure that all power (mains

and battery) is removed before

making any connections to the Node.

1. Separate the cover and base by using a

screwdriver to push 2 of the clips (left or right)

inwardfromthebaseindents,thenliftthecover

clear.

2. If the Node is being fitted inside the control

panel you may remove the Node PCB from its

base andsecureit tobase ofthe controlpanel

usingselfadhesive feet.If required,the tamper

switch may also be disabled by fitting the

jumper link across JP2, see Figure 13.

3. If the Node is being fitted outside the control

panel, hold the base in position and mark the

four securing holes. Drill and plug the wall as

required, then pass all cables into the base via

the cable entry points as appropriate. Secure

thebaseto thewallusingtheappropriatefixing

screws.

4. Connect “Node Network” cables and

detection circuit cables to the appropriate

terminals, see Figure 13.

5. Set the I/D selector jumper link to the required

position:

Node I/D

1 2 3 4 5

A 17 25 33 41 49

B 18 26 34 42 50

C 19 27 35 43 51

D 20 28 36 44 52

E 21 29 37 45 53

F 22 30 38 46 54

G 23 31 39 47 55

H 24 32 40 48 56

OPs

+A 1 3 5 7 9

-B 2 4 6 8 10

No two NODES should have the same I/D.

The NODE I/D selector DOES NOT have to

be set sequentially but it is advisable so as

to aid fault finding and programming.

6. Finally clip the Node cover onto the base

being careful not to trap any cables or to

obstruct the tamper switch.

Control Panel

To TS900

Remote

Keypad

A (Red)

AUX

12V

ENGINEERS REMOTE

JP2

C (Yellow)

B (Black)

D (White)

E (Blue)

7 Way 0.1" Molex

connector

Figure 12 Engineer's Keypad Connections

System Installation TS790 & TS900 Installation Manual

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 67 68

Comentarios a estos manuales

Sin comentarios

Menvier Security TS700 Especificaciones Pagina 14

Comentarios a estos manuales