Menvier Security TS700 Especificaciones descargar pdf (Pagina 58)

Defining Part-Set buttons to Arm a Ward(s)

Thismethodofdefiningthepartsetgroupsrequires

you to think of the system in terms of separate

areas of protection (Wards), then configuring the

part set groups so that different combinations of

wards are set.

1. From the previous part-set requirementsassign

the different physical areas to wards, e.g.:

Ward A: Downstairs perimeter detection

(Circuits 01,04, 05 & 06).

Ward B: Downstairs Internal detection (Circuits

03, 07 & 08).

Ward C: Bedroom 2 (Circuit 09).

2. Using the above ward requirements create a

Table for assigning circuits to wards. Circuits

withnoticksareassignedto the“SystemWard”:

Circuit Location Ward A Ward B Ward C

01 Front Door 4

02 Smoke Detector

03 Hall door to garage 4

04 Garage door 4

05 Garage back door 4

06 Kitchen door 4

07 Dinning room PIR 4

08 Lounge PIR 4

09 Bedroom 2 PIR 4

10 Landing PIR

3. From the above Table assign circuits 01-10 to

their relevant wards (see “Configure Wards” on

page 37).

4. Program the part set groups, see “Part set

Groups”, on page 43. This ensures that when

the user selects button A, B or C the system

arms the correct wards. When using this

method, the part set groups are programmed

as follows:

Part Set Group A: [ AB ]

Part Set Group B: [ ABC]

Part Set Group C: [ A ]

+

This method will only work correctly if

circuits are assigned only to one ward.

Ifacircuitis assigned tomorethanone

ward,it will only bearmed when all the

wards its assigned to are set.

Appendices TS790 & TS900 Installation Manual

54

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 67 68

Comentarios a estos manuales

Sin comentarios