Menvier Security TS2500 Guía de usuario descargar pdf (Pagina 19)

Key Functions

Engineer’s Reset

1. Key in engineer code default 1234. Display

shows “Engineer’s Menu 1”.

2. Press ] display shows “Engineer Onsite”.

This message will be cleared the next time a valid user

passcodeisenteredorbyexitingtheengineer'smenu

1 by pressing C and then [.

Relearn Required Message

When the system is powered up after a factory restart,

the remote keypads will display “RELEARN REQUIRED”.

On entering your engineer’s passcode the system will

automatically select the “Confirm Network Devices”

option. Afterconfirmingthecorrectnumberof devices

the “RELEARN REQUIRED” message will be cleared.

Once cleared, entering your engineer’s passcode will

select “Engineer’s Menu 1”.

Resetting the Engineer’s Passcode

If the installation engineer has inadvertently changed

the engineer’s passcode or the passcode has been

forgotten, the passcode can be reset back to 1234

without losing any other programmed data. This

procedure can only be used providing a user

passcode is available:

1. Ensure that the system is unset and a user

passcode is available.

2. Remove the cover from the control panel, this

will cause a “Panel Lid Tamper” alarm.

3. Ask the user to enter their passcode to silence

the alarm.

4. Place the blade of a small screwdriver between

the pins labelled “FACTORY RESTART”. A multi-tone

sound indicates the engineer’s passcode has

been reset.

5. Replace the control panel cover. At the remote

keypad enter 1234. The display will show

“Engineer’s Menu 1”.

Loading Defaults

To return panel to factory defaults:

1. Power down panel

2. Short factory restart pins

3. Power up battery & mains

4. Remove short

5. Enter 1234 to silence sounders

6. Replace the control panel cover. At the remote

keypad enter 1234. The display will show

“Engineer’s menu 1”.

Initial Power-Up

To power up the system for the first time:

1. Place a small screwdriver blade between

the pins on the control panel PCB, marked

“FACTORY RESTART”. This will ensure the

factory default parameters are set.

2. Switch on the 230V mains supply and remove the

screwdriver blade after 5 seconds.

3. Check that the powerLED on the control panelPCB

is illuminated.

4. Check that the remote keypads display “Panel Lid

tamper”. The remote keypad sounders and

extension loudspeakers will be operated.

5. Enter the engineer’s passcode (default 1234)

to silence the sounders.

6. Connect the standby battery.

Bell Test/Walk Test

Please refer to User Menu 1, No’s1&2respectively.

TS2500

496513 Issue A

19 of 26 TS2500

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26

Comentarios a estos manuales

Sin comentarios

Menvier Security TS2500 Guía de usuario Pagina 19

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Menvier Security TS2500