Menvier Security TS900+ Manual de usuario descargar pdf (Pagina 11)

Part-Setting Using The Part-Set Buttons

The TS790+ & TS900+ can have up to three pre-defined part-set configurations. Each

configuration allows the alarm system to set with one or more wards isolated. Each configuration

is then assigned to a part-set button A, B or C, normally this will be done by the installation

company at the time of commissioning. However the master user may also configure the

part-set buttons, providing the installation company has programmed the alarm system to allow

this facility (see “Part Set Groups” on page 39).

To part-set the alarm system, proceed as follows:

1. Enter your passcode XXXX. The

display will show:

2. Within 5 seconds press the required

part-set button A, B or C, e.g., press “A”

for part-set A. The display will show:

3. The exit sounder will start. If necessary

leave the area via the prescribed exit route.

The display will show the remaining exit time,

e.g.,

4. The system will be part-set when the exit

time has expired, on activation of the Final

Exit circuit or by pressing the Exit Terminator

button, as appropriate. When the system is

part-set the display will show the wards that

are set and the time, e.g.,

The text shown on the LCD remote keypads at step (2) may be programmed by the

master user (see “Edit Text for Part-Set Groups” on page 41). If the text is not programmed

the display will read the default “Part Set group A” for the above example.

If the alarm system has LED remote keypads fitted, the installation company may have

programmed the the system so that the alternating displays shown at step (4) only show

the time.

Part-Set A: _________________________________________________________

Setting Mode: Timed Final Exit Exit Terminator Instant

Part-Set B: _________________________________________________________

Setting Mode: Timed Final Exit Exit Terminator Instant

Part-Set C: _________________________________________________________

Setting Mode: Timed Final Exit Exit Terminator Instant

TS790+ & TS900+ User Manual Operating The System

Preparing to Set

Please Wait...

FUNCTION

Func

Setting the

Office Area Only

P. SET A

PS.A

Please Exit Now.

Time left > 0025

0025

Wards set [ A ]

05:30 Sun 28 Apr

PART SET

SET

05.30

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 56 57

Comentarios a estos manuales

Sin comentarios

Menvier Security TS900+ Manual de usuario Pagina 11

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Menvier Security TS900+