Menvier Security TSD401 Guía de usuario descargar pdf (Pagina 6)

TSD402 & TSD401

TSD402 & TSD401 6of10 496523 Issue A

Initial Power-Up

1. Placeasmall screwdriverbladebetweenthepins

on the Control Panel PCB, marked FACTORY

RESTART (located top left corner). This will ensure

that the factory default values are loaded into

memory as show below:

Engineer's Passcode - 1234

User 1 Passcode - 5678

User 2 Passcode - Not programmed

Zone 1 - Night

Zone 2 - Access

Zone 3 - Night

Zone 4 - Night

Zone 5 - Night

Final Exit - Exit

Exit Time - 030 Seconds

Entry Time - 030 Seconds

Bell Duration - 020 Minutes

Remote Reset Number - 004

Bell Output - SAB (-ve Applied)

Setting Mode - Timed Exit

Reset Authority - User Reset

Number of Re-arms - 3

Operation of Key Switch - AWAY Set (Full)

Operation of RST Output - Switched 12V

Operation of Final Exit in P/Set - Final Exit

HOME Setting - Zone 1 Omitted

Dialler Alarm Options - No Alarms Report

Acknowledgement Option - Cleared by any 1

2. Switch on the 240V mains supply and remove

the screwdriver blade. The internal alarm will

bleep every 30 seconds the display will show:

CF- T.

3. Connect the standby battery. If the display

shows: BATT.FLT and the internal alarm

sounds, then the battery may have been

incorrectly connected or its voltage is below 8V.

Disconnect the battery immediately and

reconnect or replace as appropriate.

4. Push the battery into place at the bottom of the

housing and re-fit the front cover.

5. The display will show: PLEASE RE-RECORD,

this message will only be cleared when one or

more of the speech dialler messages has been

recorded.

6. Enter the engineer's passcode (default

12

34

), the display will show: ENGR. OPTION -

(engineer programming menu selected)

7. Thetelephoneleadcan now bepluggedintothe

telephone socket.

8. Fitthebatterylink intheexternalsiren andreplace

cover.

9. The system is now ready for engineer

programming

Log Event Codes and Descriptions

Display Description

AC OFF

Mains power removed.

AC ON

Mains power restored.

AU PL TA

Auxiliary or panel lid tamper alarm.

BATT FLT

Battery fault (battery reversed or

below 10.5V).

CCT AL -

Full alarm from zone1-5(F=Final

Exit when part-set).

CODE TA

Code Tamper (4 incorrect

passcode entries).

ENTRY TO

Entry timed-out (system not unset

after activating F/Exit zone).

FIRE AL

Fire Alarm activated.

SET A

AWAY Set.

SET FAIL

System failed to set (zone still active

at end of exit time).

SET H

HOME Set.

USER -

User 1 or 2 passcode entered (User

3 = keyswitch).

--------

No Event

1 2 3 4 5 6 7 8 9 10

Comentarios a estos manuales

Sin comentarios