Menvier Security TS700 Manual de instrucciones descargar pdf (Pagina 11)

Sounder Connections

The external and internal sounder can be connected to the control panel u sing the following

connections:

AUX TAMP - These terminals pr ovide tamper protection to auxiliary devices such as

power supplies, extension loudspeaker units etc.

SPK+ - Extensi on loudspeakers may be connected between [SPK+] and [H/O-].

The minimum impedanceis 16Ohms. Upto twomaybe connectedto the

control panel.

Do NOT run extension loudspeak ers within the same cabling as remote

keypads or LECs.

H/O - - This is used to p rovide a permanent -ve hold off to external sounder s.

H/O + - This is used to provide a permanent +ve hold off to externa l so unders,

strobes etc. It is protected by a 1 Amp fuse (Bell 12V).

TR - - This is the negative tamper return connection from the siren or bell.

STB - - This is the strobe output which w ill switch to 0V on alarm and draws a

maximumof5 00mA.Connecttheothersi deofthestrobetothe[H/O+].

TRG - - This output can be programmed to be either an SAB or SCB and opera tes

as f ollows:

SAB: TRG -willswitchto 0Vonal armandwillsinkamaximumof500mA.

SCB: TRG - will provide a negat ive hold off, which is removed on alarm.

TS700 Installation Manual System Installation

Typical

External Sounder

Control

Panel

H/O -

H/O +

+12V

Tamper In

TR -

STB -

Tamper Out

TRG -

Strobe +ve

Strobe -ve

Trigger -ve

Figure 7. External and Internal Sounder Connections

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Sin comentarios

Menvier Security TS700 Manual de instrucciones Pagina 11