Menvier Security TS700 Manual de usuario descargar pdf (Pagina 4)

Operating the System

1. Introduction

System operation can only be carried out after entering your

passcode. Up to twelve passcodes can be allocat ed and they

canonlybedefinedbythe"masteruser"(user1).UsersA,BandC

can only set and unset their respectiv e areas. E ntering a

passcode with the first two digits reversed will cause a "Dure ss

Alarm". Eachkeypress isacknowledgedby thekeypad sounder.

Pressing the [ES C] key takes the user back t o the previous step in

the menu.When the systemis notbeing usedthe keypad dis play

shows the current time. The "ENG ON SITE" message is displayed

afteran engineerhas lefthismenuandisclearedthe nexttimea

user passcode is entered .

2. Full Setting the System

Ensure that all monitored areas are secured. Enter your

passcode(users1 to9 on ly)and the di splay wil l show"Func".After

five seconds the display will show how much time is left b efore

the system is set and the sounder makes a continuou s tone.

Le ave via the n ormal exit route and close the final exit door

(pressing the Exit Terminator button if fitted). The system is full set

when the exit sounder stops, the display will s how ‘SET’ for five

seconds then reverts to showing the current time.

WARNING: If an attempt is made to set t he system whilst any

circuits are active (such as a door being open), the display will

indicate the circuit s that are in fault and the internal sounder

generates an i nterruptedtone. Thefault must be cleared before

the setting procedure can be completed. If t he system is set by

‘Timed Exit’ and the fault is still present at the end of the exit t ime

an internal alarm will be generated. If fitted, the external strobe

lig ht will flash indicating the system has failed to set. To prevent

thi s alarm simplyre-enteryourpasscodebeforethetimeexpires.

3. Part Setting the System (user s 1 To 9)

Ensure that all monitored areas are secured. Enter your

passcode (users 1 to 9 only) and within 5 seconds press [A] or [B]

or [C] (depending upon the part set area required). If the five

seconds is exceede d the system will full se t. The displa y shows

the selected group/area that will be omitted and the sounder

makes a continuou s tone. If required l eave via the normal exit

route and close the final exit door, (pressing the E xit Terminator

button iffitted). The system ispartsetwhentheexitsounderstops,

the display willalternate between the group/area thatisomitted

and the current time.

TS700 LED User Operating Instructions

This is the normal display when

the system is set or unset. The

time is displayed and the "dot"

segment flashes

ENG

SITE

Ent er user passcode to clear

Func

User passcode entered

9999

This f igure indicates the time to

set in secs. 9999 indicates the

system is being set by Last Exit or

Exit T erminator. Any other figure

is timed exit.

SET

The display will show se t for 5

seconds, t hen revert to only

displaying the ti me.

Func

User passcode entered

Omit button [A] is p ressed.

SET

The display shows the group

that has been omitted (A).

1 2 3 4 5 6 7 8 9 ... 15 16

Comentarios a estos manuales

Sin comentarios

Menvier Security TS700 Manual de usuario Pagina 4

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Menvier Security TS700