Menvier Security TS510 Instrucciones de operaciones descargar pdf (Pagina 6)

7. BT. Connections

1. Connect telephone line using one of the methods shown below:

2. Replace the plastic cover over the telephone line connections.

8. Commissioning and Testing

1. If the SD1+ is not being used in the UK please ensure the options switch is set to the

appropriate settings, see section 9.

2. Hold the blade of a small screwdriver between the “Factory Restart” pins (JP2) and

switch the power back on to the control panel (battery and mains).

3. Remove the screwdriver blade and clip the SD1+ front cover onto the base taking

care not to trap any cables.

4. The SD1+ "beeps" every 30 seconds and the display shows:

To select the programming mode enter the default passcode of 1234 .

6. The display will show

. The unit is now ready for programming and testing. Please

refer to the ”Operating Instructions” for full details.

White

Red

Standard BT telephone plug

SD1+

White/Blue

BT Master Jack (NTE5)

User accessible connections

Cable type 1/0.5mm CW1308

Blue/White

Method 1 - Using the lead supplied

Method 2 - Hard wired connections

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Sin comentarios

Menvier Security TS510 Instrucciones de operaciones Pagina 6