Menvier Security TS510 Instrucciones de operaciones descargar pdf (Pagina 3)

2. Installation Requirements

The SD1+ has been designed to be connected to an intruder alarm control panel or

similar. The control panel must have an auxiliary power output of between 11.5V and 14V,

and the ability to provide a minimum of 100mA.

The unit is supplied with a 2 metre telephone lead which will plug directly into any standard

BT socket and it is therefore recommended that the unit is sited as near to a BT telephone

socket as possible. If this it not possible an approved BT extension lead may be required or

the unit can be hard wired to the BT. socket (see section 8).

3. Mounting Instructions

1. Separate the cover from the base by using a screwdriver to push two of the retaining

clips (top or bottom) inwards from the base indents. Remove cover assembly and

store in a safe place.

2. Hold the base in position (keyhole to the top) and mark the three securing holes.

Remove the base then drill and plug the holes.

3. Pass all cables into the base through the cable entries and then secure the base to

wall.

4. PCB Layout



Loudspeaker



Trigger Polarity



Tamper Switch



Telephone Connections (TNV)



Microphone



Country Setting (Not fitted on UK product)



Tamper connections (SELV)



12V Supply and Programmable O/P (SELV)



Trigger Inputs (SELV)



Factory Restart Pins

TRIG INPUTS

+12V

O/P1 -ve

SD1+

TELEPHONE CONNECTIONS

BA1B1

ABORT

TAMP

FACTORY RESTART

TRIGGER

POLARITY













1 2 3 4 5 6 7 8 ... 27 28

Comentarios a estos manuales

Sin comentarios

Menvier Security TS510 Instrucciones de operaciones Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Menvier Security TS510