Menvier Security TS400 Manual de usuario descargar pdf (Pagina 30)

Problem - The display shows UNSET AC OFF and the internal sounders beeps every

minute.

Cause - The mains power to the panel is off or the internal fuse has blown. The system

will operate from the internal battery for about 8 hours.

Action - Enter you passcode to silence the beeps, if the mains power to the building is

on, contact your alarm company.

Problem - When setti ng the system, the outside strobe start s to flash.

Cause - This shows that the system has failed to set correctly.

Action - Re-enter the building and enter your passcode to unset the system. Check that

all doors and windows are closed, and try again.

Problem - Although I follo w the correct procedure, the system will not allow me to change

my passcode.

Cause - The TSD402 analyses the new code entered and may refuse to accept certain

code combinations for technical reasons.

Action - Try repeating the procedure with a different passcode.

Problem - The TSD402 `beeps' ev ery 30 seconds and the display shows:

PLEASE RE-RECORD

Cause - The mains and battery power for the system has been interrupted, and the

speech dialler messages have been erased.

Action - Re-program all messages as required (contact your installation company for

further advice if the the problem re-occurs).

Speech Dialler Troubleshooting

Problem - The uni t will not dial the tele phone number that I have pr ogrammed.

Cause - Number incorrectly dialled

Action - Check the telephone number you are calling has been entered correctly.

Problem - When sending a Tes t call the di splay shows: NO REPLY

Cause - The call was not answered or acknowledged by the recipient.

Action - Ring the recipient and check they have followed the call acknowledgement

procedure.

Problem - When sending a Tes t call the th e display sho ws: ENGAGED

Cause - The recipient is on another call.

Action - Wait until they have finished the call and try again.

Problem - When sending a Tes t call the di splay shows: UNOBTAINABLE

Cause - The TSD402 has dialled the number and detected something other than a

`ringing' or `engaged' tone (e.g., a B.T. or Cellnet recorded message).

Action - Check the number using a normal telephone or try again.

Troubleshooting TSD402 User Manual

1 2 ... 25 26 27 28 29 30 31 32

Sin comentarios

Menvier Security TS400 Manual de usuario Pagina 30