Menvier Security TS400 Manual de usuario descargar pdf (Pagina 22)

Sending a Test Call

Itispossibletotestthateachmessageplaystoeachofthetelephonenumbers.e.g.,youmaywant

to test that ` Alarm Message' plays to telephone number 1 or the `Fire Message' to telephone

number 3 etc.

Beforesendingatest call itisveryimportant that the personthatis being called isfamiliarwiththe

CallAcknowledgementProcedure.ThiswillensurethattheTSD402issuccessfullycleareddown.

If the TSD402 is not cleared down when it is triggered it will either dial the next telephone number

(if one is programmed) or re-dial the first telephone number a further two times.

Operation

Once a test call is initiated the unit will dial the

telephone number and wait until ringing tone is

detected. When the unit detects the tone, the

display will show `Ringing'. If the ringing tone is not

detected within 5 seconds the unit will start to play

the message. If the ringing tone is detected the unit

will wait until the person picks up the call. If after 1

minute the call has not been answered the display

will show `NO REPLY' then the unit will re-dial the

number.

The unit plays common phrase (Name & Address)

then the selected phrase (Fire, PA or Alarm). At the

endof theselectedphrase,theperson receivingthe

call must carry out the Call Acknowledgement

Procedure.

If the call is successfully acknowledged the display

will show `CALL SUCCESSFUL'. If the person

receiving the call fails to acknowledge it on the first

attempt the unit will repeat the message four times,

givingthemtheopportunitytoacknowledgethecall

at the end of each message. However if at the end

of the last attempt they still fail to acknowledge the

call the display will show `NO REPLY'. The unit will

clear down for 6 seconds, then re-dial the

telephonenumberforasecondattempt,intotalthe

unit will only attempt the telephone number three

times before shutting down completely.

Note:Test calls may be cancelled at any time by

pressing the ] key.

User Options TSD402 User Manual

Sending a Test Call

READY

Sele ct the message to be

sent then the telephone

number

READY

(e.g., press

then

send the Fire message to

telephone No. 2)

PLAYING PHRASE 0

PLAYING PHRASE A

RINGING

CALL SUCCESSFUL

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Comentarios a estos manuales

Sin comentarios

Menvier Security TS400 Manual de usuario Pagina 22

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Menvier Security TS400