Menvier Security TS400 Manual de instrucciones descargar pdf (Pagina 30)

Returning to the Unset Mode (key

]

)

Once all the engineer programming is completed the system can be returned to the unset

mode by pressing the

]

key. However since the speech dialler has not yet been

programmed the display will still show the "PLEASE RE-RECORD" message. This will be

cleared when one or more of the speech dialler messages have been recorded (see User

Manual for full details).

Full Setting the System (AWAY)

The engineer may use his passcode to Set the system as follows:

1 Enter first two digit of engineer's passcode then press the

]

key (e.g.,

1 2 ]

2 The exit tone will start and the display shows the remaining time.

3 When the exit tone stops, the system is full set.

Part-Setting the System (HOME)

The engineer may use his passcode to part-set the system as follows:

1 Enter first two digit of engineer's passcode then press the

[

key (e.g.,

1 2 [

2 The display shows the remaining time (part-set is always silent).

3 When the two-tone sound is heard, the system is part-set.

Unsetting the System

The engineer may only use his passcode to unset the system when the system is set or

part-set using the engineer passcode (i.e., if the system is set by the user the engineer

passcode will NOT unset the system).

1 Enter via the prescribed entry route.

2 The entry tone will start and the display will show the remaining time.

3 Enter the engineer's passcode (e.g.,

1 2 3 4

4 The display shows UNSET.

Programming TSD402 Installation Manual

1 2 ... 25 26 27 28 29 30 31 32

Sin comentarios

Menvier Security TS400 Manual de instrucciones Pagina 30