Menvier Security TS2500 Manual de usuario descargar pdf (Pagina 36)

Fault Finding Display Messages

One or more circuits have failed during a test

routine initiated by your alarm company. You

can still set and unset your wards but you should

contact your alarm company for further advice.

One or more wards have been isolated so that

24hr protection with those wards can be

accessed. Press

[ to display which wards are

currently isolated.

The TS2500 has an auto-set feature which will

automatically set and unset specified wards at

pre-programmed times, This message is

displayed one minute before the wards are due

to set and a chime tone is generated every ten

seconds to warn you to leave the area. If you

have the appropriate access code you can

defer the automatic setting by entering your

passcode and choosing the "DEFER SETTING"

option.

The alarm system requires a routine

maintenance visit from your alarm company.

You can still set and unset your wards but you

should contact your alarm company for further

advice.

Your alarm company has enabled the payment

timer and the timer has expired. You cannot set

your wards and should contact your alarm

company for further advice.

Your alarm company has had an engineer on

site and is logged into the alarm system. You can

continue to operate the system as normal, if

required. The message is automatically cleared

when the engineer logs off.

The hardware configuration of your alarm system

has changed. You may not be able to set your

wards and should contact your alarm company

for further advice.

34

TEST CCTS FAILED

12:00 Sun 01 JAN

! AUTO SETTING !

12:00 Sun 01 JAN

SERVICE REQUIRED

12:00 Sun 01 JAN

PAYMENT REQUIRED

12:00 Sun 01 JAN

ENGINEER ON SITE

12:00 Sun 01 JAN

RELEARN REQUIRED

12:00 Sun 01 JAN

WARDS ISOLATED

12:00 Sun 01 JAN

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 47 48

Comentarios a estos manuales

Sin comentarios