
User Menu 3 Use On-line Pad
User menu 3
Select option :-
SYSTEM OPEN
18:10 Sun 01 JAN
User menu 3
Use on-line pad
0181234567
Call No.1 Office
3
ENT
ENTENT ENT
? ? ? ?
1
2
3
B
=Dial No.1
=Dial No.2
=Dial No.3
=Dial this number
e.g.
1
ENT
Please wait.....
Dialing Number 1
Please wait.....
Waiting connect.
Please wait.....
Syncronising lnk
Please wait.....
Password check
Please wait.....
* ON-LINE *
SYSTEM OPEN
18:10 Sun 01 JAN
This is the display of
the remote site.
Press [ESC] six times to
close the link with the
remote site
Please wait.....
Closing link
If your alarm system has been fitted with a
modem, you can use this option to connect
to another TS2500 alarm system (providing
the system also has a modem fitted). Once
a connection has been established your
own remote keypad will behave as if it were
connected to the remote site. For example
you could use this option to connect to
another TS2500 alarm system and once
on-line you can use your own keypad to set
the remote system.
1. At the remote keypad enter your
passcode then press [ENT] three times to
select user menu 3.
2. Press [3] followed by [ENT] to select the
use on-line pad option.
3. Pressing [1] - [3] will display the remote
site(s) telephone number(s). If the
number is not listed, press [B] and enter
the telephone number required.
4. When the display shows the required
telephone number press [ENT] to start.
5. The system will attempt to connect to
the remote site. Once connected the
display will show the display of the
remote site. you can use your keypad to
control the remote site, e.g. if you enter
a valid passcode for the remote site you
can set/unset the remote site.
6. To abandon on-line keypad mode press
[ESC] six times. The display will show "User
menu 3". Press [ESC] three times to return
the system to its original state.
32
Comentarios a estos manuales