Menvier Security TS400 Manual de usuario descargar pdf (Pagina 4)

Unsetting The System

To unset the system, proceed as follows:

1 Enter the premises via the designate entry door. The

internal sounder will sound.

2 Proceeddirectly to the keypad and enter all 4 digits of

your passcode.

3 The sounder will stop and the unset indicator will light.

The system is now unset.

If the programmed entry time is exceeded, the

internal sounder will emit an alarm tone for the

duration of the programmed entry time. If a valid

passcode is not entered at the keypad before the

addition time expires, a full alarm will occur, i.e.

internal and external alarm.

Resetting After an Alarm

When an alarm has occurred the system will require resetting before the system can set again.

Your alarm company will have configured your system to be reset by one of the following

methods:

User Reset: ❏ Engineer Reset: ❏ Remote Reset: ❏

When an alarm occurs with the system full or part set proceed as follows:

1 Enter the premises via the designate entry route. The

internal sounder will sound.

2 Proceeddirectly to the keypad and enter all 4 digits of

your passcode.

3 The sounder will stop and the unset indicator will light.

The zone indicators associated with the alarm

condition will also light.

4 Check the system as necessary.

5 Enter your passcode again to reset the system. The

zone indicator that was lit will go out. The system is now

reset.

If after unsetting the system the internal sounder

continues to emits a pulsed tone, the system will

require a reset by either engineer or remote reset. To

silence the pulsed tone, enter your passcode.

Forengineerresettelephone:

For remote reset telephone:

Enter the building via the designated

entry point. Proceed directly to the keypad

and enter all 4 digits of your passcode.

The system is now unset.

? ?? ?

Enter the building via the designated

entry point. Proceed directly to the keypad

and enter all 4 digits of your passcode.

The system is unset and the zone that

caused the alarm is indicated

(e.g. zone 3).

? ?? ?

The system is now reset.

1 2 3 4 5 6 7 8

Comentarios a estos manuales

Sin comentarios

Menvier Security TS400 Manual de usuario Pagina 4

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Menvier Security TS400