Menvier Security TS2500 Manual de instalación descargar pdf (Pagina 8)

Output Modules

The Output Module provides eight switched negative

outputs capable of supplying 100mA each to drive LEDs

or miniature relays. You can daisy chain up to 128

Ouput Modules together, connecting the first one to the

Ouput Module connector JP2 on the control panel

main pcb.

Programming OM Options (Engineers Menu

4 option 7)

There are two sub-options in this command: ward

mimic and circuit mimic.

Ward mimic provides a list of ward information that you

can send to the output modules. The control panel

transmits every item in the list that you say yes to. The first

output module picks up the first item transmitted, the

second module picks up the second item, and so on.

Circuit mimic provides eight blocks of circuit numbers

that you can select. For each block you choose the

starting and ending circuit number. A block can cover

all the circuits connected to the panel, or a single

circuit. The control panel sends all the selected circuits

to the output modules remaining after those used by

the ward mimic infomation. Each LED corresponds to a

circuit.

Example

Figure 5 shows an example using four Output Modules.

During programming Mimic Options 00 and 02 have

been selected as Yes. All other Mimic Options are No.

This means that Output Module 1 will respond to Ward

A-H Bell and Output Module 2 will respond to Ward A-H

Strobe.

In the example two blocks of circuits have been

defined. Start 1/End 1 specifies circuits 1001 to 1008

and Start 2/End 2 specifies circuits 2001 to 2008. This

means that Output Modules 3 will respond to circuits

1001 to 1008, and Output Module 4 will respond to

circuits 2001 to 2008.

Output Modules Connected to XNodes

Each XNode is capable of driving one, and only one,

Output Module. When connected to an XNode an

Output Module mimics the eight circuits of that XNode,

and no others.

TS2500 Hints and Tips

To control

panel

Ward Bell A-H Ward Strobe A-H Circuit Mimic

1001-1008

Circuit Mimic

2001-2008

No. Mimic Option Yes/No

00 Ward A-H Bell SAB Yes

01 Ward I-P Bell SAB No

02 Ward A-H Strobe Yes

03 Ward I-P Strobe No

04 Ward A-H SW12V No

05 Ward I-P SW12V No

81 Internal Digi No

Circuit Mimics

Start 1 1001 End 1 1008

Start 2 2001 End 2 2008

OM 1 OM 2 OM 3 OM 4

Wards

A-H Bell

To Control Panel

Wards

A-H Strobe

Circuit Mimic

1001-1008

Circuit Mimic

2001-2008

Figure 5. Output Mocule Example

Part No. 496504 Issue 1

1 2 3 4 5 6 7 8

Comentarios a estos manuales

Sin comentarios

Menvier Security TS2500 Manual de instalación Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Menvier Security TS2500